Visioneer PaperPort Strobe 500 Guide d'installation télécharger pdf (Page 10)

6 VISIONEER STROBE XP 200 SCANNER INSTALLATION GUIDE

12. On the Visioneer Registration screen, complete the required

information and click Register.

13. When you see the Connect Scanner window, do NOT click Finish.

Leave the window open and proceed to the next section, “Step 2:

Connect and Calibrate the Scanner”.

STEP 2: CONNECT AND CALIBRATE THE SCANNER

The Visioneer Strobe XP 200 scanner connects to any available USB

port. Check your computer’s manual for USB port locations.

To c o n n e c t yo u r V i s i o n e e r Strobe XP 200 scanner:

1. Plug the AC adaptor cable into the power jack on the USB/power

cable, and then plug the AC adapter into an electrical outlet.

2. Plug the XP 200 connector on the USB/power cable into the port

on the back of the scanner.

3. Plug the USB connector on the USB/power cable into any USB

port on your computer.

Note: You can connect the scanner to your computer while the

computer is running. You do not have to shut down your computer.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Pas de commentaire

Visioneer PaperPort Strobe 500 Guide d'installation Page 10