Visioneer 9420USR Guide de l'utilisateur télécharger pdf (Page 15)

STEP 2: CONNECT THE SCANNER 11

3. Plug one end of the USB cable into an available USB 1.1 or USB

2.0 port on the computer.

4. Plug the other end of the USB cable into the scanner’s USB port.

If the plug does not attach easily, make sure that you are plugging it

in correctly. Do not force the plug into the connection.

You can also connect the scanner to a USB port on the computer’s

keyboard if it has one, or to a USB hub. If you use a USB hub, it

must have its own power supply already plugged into an electrical

outlet.

If you are using Windows XP and have plugged the USB cable into

a USB 1.1 port, an information bubble may open explaining that

“A HI-SPEED USB device is plugged into a non-HI-SPEED USB

hub”. Plug the USB cable into a USB 2.0 port (if available) or just

disregard the message. If you leave it plugged into the USB 1.1

port, your scanner may scan a bit slower than with a USB 2.0 port.

Note: If you have not installed the software, unplug the USB cable

from the computer and install the software now. When the software

installation is complete, a message tells you to connect the scanner.

USB

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 105 106

Pas de commentaire

Visioneer 9420USR Guide de l'utilisateur Page 15